3. Names of each part
●
Part names
Projector
Vent
Lens
Lens cover
Lamp cover
(Lamp unit is inside.)
Control buttons
Ports
(See below.)
RGB port
Restart switch
CONTROL port
Kensington lock slot
NOTE (*) About Restart switch: This Projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
ViewSonic Corporation
Front-Right side
Bottom side
Rear-Left side
CONTROL
RGB
S-VIDEO
K
Ports
3
Focus ring
Remote sensor
Speaker
Elevator button
Elevator foot
Filter cover
(Air filter and intake vent
are inside.)
Power switch
AC inlet
Elevator button
Elevator foot
Vent
S-VIDEO port
VIDEO port
VIDEO
AUDIO
AUDIO port
Confidential - Do Not Copy
PJ452