Optoma EH501 User Manual page 51

5. Press /
6. When you press "Menu", a confirm message will pop-up to ask you if you
want to save the settings.
Important
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask, Default
Gateway, and DNS settings will display 0.0.0.0. Make sure the cables are properly
connected and perform the procedures above again.
If you wish to connect to the projector in its standby mode, be sure you have selected
RJ45 and obtained the IP Address, Subnet Mask, Gateway, and DNS information when
the projector is on.
to move the cursor and enter the value.
EN-51