Table of Contents
Advertisement
Solving Problems
If you have a problem with your LabelWorks,
check the display or the troubleshooting
suggestions below.
Error messages
Insert tape
Turn the power off and install a
tape cartridge.
Check battery
The batteries may be running out
or installed incorrectly, non-
alkaline batteries are being used
with alkaline batteries, or old and
new batteries are being used
together. Turn the power off and
replace batteries with new ones,
or use the optional AC adapter.
Make sure new batteries are
installed correctly.
Too many lines
You have exceeded the maximum
number of lines (2). Press
delete the lines indicated by the
cursor.)
Seq. num. only 1
Sequence numbers have already
been set. You can only enter one
sequence number per label.
24
|
Solving Problems
Txt too long-OK?
Overheated!
Cover open!
Delete all text?
Motor error!
to
Entered text is too long for the
specified tape length. Press
and adjust the label length or
make text shorter.
The print head is too hot. Turn the
power off and take out the tape
cartridge. Allow the print head to
cool before trying to print again.
If you open the rear cover while
the power is on, this message
displays and the power turns off
automatically. Always turn the
power off before opening the rear
cover.
When creating a label with a
special format, the current text
will be deleted. Press
delete the text and show the
special format.
An error occurred in the motor
operation. Turn the power off,
then turn it back on. If the same
message appears, turn the power
off again and contact Epson for
technical support.
to
Advertisement
Table of Contents
