Charcoal Filter - GE JNM7196SFSS Use And Care Manual

About the exhaust feature.
Sensor Microwave
Popcorn Potato Beverage
Family Snacks MyPlate
Steam Soften
Defrost
Reheat
Weight/Time
Express Cook
Add
30 Sec
Cook
Time
Settings
Power
Saver
C ancel Start
Pause
O ff
Lock Controls
Hold 3 Sec
Timer Vent Surface
On/Off Fan Light
Remove 2 grille screws to remove
the grille.

Charcoal Filter

Sales No. JX81H
The charcoal filter cannot be cleaned. It must
your GE supplier.
If the model is not vented to the outside, the
air will be recirculated through a disposable
charcoal filter that helps remove smoke and
odors.
To Remove the Charcoal Filter
To remove the charcoal filter, first disconnect
power at the main fuse or circuit breaker, or pull
the plug. Remove the top grille by removing the
two screws that hold it in place.
You may need to open the cabinet doors to
remove the screws.
To Install the Charcoal Filter
To install a new charcoal filter, remove plastic
and other outer wrapping from the new filter.
Insert the top of the filter up and into the
grooves on the inside of the top opening. Push
the bottom of the filter in until it rests in place
behind the tabs.
The charcoal filter should be replaced when it is
noticeably dirty or discolored (usually after 6 to
12 months, depending on usage). See "Optional
Kits," page 10, for more information.
Lift the filter at the bottom until it comes free of
the tabs. Slide the filter down and out.
GEAppliances.com
25