GE JNM7196SFSS Use And Care Manual page 24

Replacing the light bulb.
Sensor Microwave
Popcorn Potato Beverage
Family Snacks MyPlate
Steam Soften
Reheat Defrost
Weight/Time
Express Cook
Add
30 Sec
Cook
Time
Settings
Power
Saver
C Start
ancel
O ff Pause
Lock Controls
Hold 3 Sec
Timer Vent Surface
On/Off Fan Light
Remove screw.
Sensor Microwave
Popcorn Potato
Beverage
Family Snacks MyPlate
Steam Soften
Reheat Defrost
Weight/Time
Express Cook
Add
30 Sec
Cook
Time
Settings
Power
Saver
C Start
ancel
O ff Pause
Lock Controls
Hold 3 Sec
Timer Vent
On/Off Fan
About the exhaust feature.
Charcoal filter (on some models).
Sensor Microwave
Popcorn Potato Beverage
Family Snacks MyPlate
Steam Soften
Defrost
Reheat
Weight/Time
Express Cook
Add
30 Sec
Cook
Time
Settings
Power
Saver
C ancel Start
Pause
O ff
Lock Controls
Hold 3 Sec
Timer Vent Surface
On/Off Fan Light
Reusable vent filters
(on all models).
Popcorn Potato Beverage
Family Snacks MyPlate
Steam Soften
Reheat Defrost
Weight/Time
Express Cook
Add
30 Sec
Cook
Time
Settings
Power
Saver
C ancel Start
O ff Pause
Lock Controls
Hold 3 Sec
Timer Vent Surface
On/Off Fan Light
24
Cooktop Light/Night Light
GE supplier.
1
To replace the cooktop light/night light, first
disconnect the power at the main fuse or
circuit breaker panel, or pull the plug.
2 Remove the screw from the side of the light
compartment cover and lower the cover
until it stops.
Surface
Light
Vent Fan
The vent fan has two metal reusable vent filters.
Models that recirculate air back into the room
also use a charcoal filter.
Reusable Vent Filters
The metal filters trap grease released by foods
on the cooktop. They also prevent flames from
foods on the cooktop from damaging the inside
of the oven.
Removing and Cleaning the Filters
To remove, slide them to the rear using the
tabs. Pull down and out.
To clean the vent filters, soak them and then
swish around in hot water and detergent. Don't
use ammonia or ammonia products because
they will darken the metal. Light brushing can
be used to remove embedded dirt.
Rinse, shake and let dry before replacing.
3 Be sure the bulb is cool before removing.
Break the adhesive seal by gently
unscrewing the bulb.
4 Screw in the new bulb, then raise the light
cover and replace the screw. Connect
electrical power to the oven.
For this reason, the filters must always be in
place when the hood is used. The vent filters
should be cleaned once a month, or as needed.
To replace, slide the filters into the frame slots
on the back of each opening. Press up and to
the front to lock into place.