Removing The Video Card/Thermal Cooling Assembly; Replacing The Video Card/Thermal Cooling Assembly - Dell Inspiron XPS Gen 2 Service Manual

Back to Contents Page
Video Card/Thermal Cooling Assembly
Dell™ Inspiron™ XPS Service Manual
Removing the Video Card/Thermal Cooling Assembly
Replacing the Video Card/Thermal Cooling Assembly
Removing the Video Card/Thermal Cooling Assembly
CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTE: If you ordered a video card with your computer, it is already installed.
1. Follow the instructions in "Before Working Inside Your
1. Remove the center control cover.
2. Remove the keyboard.
3. Remove the display assembly.
4. Remove the palm rest.
NOTE: Remove the video card/thermal cooling assembly as a single unit. Do not separate the thermal cooling assembly from the video card.
5. Loosen the four captive screws from the video card/thermal cooling assembly.
6. Gently pull up the video card/thermal cooling assembly from the system board.
1 video card/thermal cooling assembly
2 captive screws (4)
3 system board connector
Replacing the Video Card/Thermal Cooling Assembly
1. Carefully re-align the video card/thermal cooling assembly over the connector on the system board and press down.
NOTE: The video card/thermal cooling assembly is labeled "PUSH HERE."
Computer."