Display Assembly; Removing The Display Assembly - Dell Inspiron Mini 10v N Service Manual

Back to Contents Page
Display
Dell™ Inspiron™ 1011 Service Manual
Display Assembly
Display Bezel
Display Panel
Display Panel Cable
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
computer.
Display Assembly

Removing the Display Assembly

1. Follow the instructions in Before You
2. Remove the battery (see Removing the
3. Remove the keyboard (see
4. Remove the palm rest (see
5. Remove the hard drive (see
6. Remove the palm rest bracket (see
7. Remove the USB and SIM card board (see
8. Remove the AC adapter connector (see
9. Remove the system board without removing the memory module and coin-cell battery (see
10. Make note of the Mini-Card cable routing and pull the Mini-Card cables out of the computer base.
11. Remove the two screws that secure the display assembly to the computer base.
1

display assembly

12. Lift and remove the display assembly from the computer base.
Begin.
Battery).
Removing the Keyboard).
Removing the Palm Rest).
Removing the Hard Drive).
Removing the Palm Rest Bracket).
Removing the USB and SIM Card
Removing the AC Adapter
2 screws (2)
Removing the
Board).
Connector).
Removing the System
Battery) before working inside the
Board).