Gigabyte GA-970A-D3P User Manual page 53

C. Configuring a RAID array in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step if you do not want to create RAID
array on the SATA controller.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message which
says "Press <Ctrl-F> to enter RAID Option ROM Utility" (Figure 2). Press <Ctrl> + <F> to enter the RAID BIOS
setup utility.
RAID Option ROM Version 3.3.1540.17
(c) 2011 Advanced Micro Devices, Inc. All rights reserved.
No Array is defined..
Press <Ctrl-F> to enter RAID Option ROM Utility...
Step 2:
Main Menu
(Figure 3)
To view the disk drives assigned to arrays, press <1> to enter the View Drive Assignments window.
To create an array, press <2> to enter the LD View/LD Define Menu window.
To delete an array, press <3> to enter the Delete LD Menu window.
To view controller settings, press <4> to enter the Controller Configuration window.
Option ROM Utility (c) 2011 Advanced Micro Devices, Inc.
Press 1..4 to Select Option
Figure 2
[ Main Menu ]
View Drive Assignments........................... [ 1 ]
LD View/ LD Define Menu...................... [ 2 ]
Delete LD Menu....................................... [ 3 ]
Controller Configuration............................ [ 4 ]
[ Keys Available ]
Figure 3
- 53 -
[ESC] Exit
Configuring SATA Hard Drive(s)