Pioneer X-HM10-K Operating Instructions Manual page 25

Speaker Setup (HTP-FS510)
4 Insert the speaker cable from the hole
behind the base through to the pole.
5 Connect each speaker.
Connect the wires to the speaker. Each
speaker in the illustration can be identified by
means of the color-coded indicator provided on
the rear-surface label.
Front left: White
Front right: Red
Match the color-coded wire with the color
indicator on the label, then insert the color-
coded wire into the red (+) side and the other
wire into the black (–) side.
(–) Red (+)
Black
Connect the other end to the color-coded
speaker terminals on the rear of the receiver
subwoofer.
Color-coded tab (+)
(–)
Black
Color-coded wire
Color-coded wire
• When connections are completed, secure
the speaker cables. Fix the cables to the
groove in the speakers.
CAUTION
• These speaker terminals carry
HAZARDOUS LIVE voltage. To prevent
the risk of electric shock when connecting
or disconnecting the speaker cables,
disconnect the power cord before touching
any uninsulated parts.
• Only those speakers supplied, or
purchased as an officially supported
option, should be connected to this
system.
• Do not connect the supplied speakers to
any amplifier other than the one supplied
with this system. Connection to any other
amplifier may result in malfunction or fire.
• After connecting the plugs, pull lightly on
the cables to make sure that the ends of
the cables are securely connected to the
terminals. Poor connections can create
noise and interruptions on the sound.
• If the cable's wires happen to be pushed
out of the terminals, allowing the wires to
come into contact with each other, it
places an excessive additional load on the
amp. This may cause the amp to stop
functioning, and may even damage the
amp.
01
25
En