Safety Precautions - Bosch KBE-495V28-20N Instruction Manual

FCC & ICES INFORMATION
(U.S.A. and Canadian Models Only)
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including inter-
ference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of the FCC Rules
and ICES-003 of Industry Canada. These limits are designed to provide
reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates,
uses and radiates radio frequency energy, and if not installed and used
in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a residen-
tial area is likely to cause harmful interference, in which case the user
will be required to correct the interference at his expense.
Intentional or unintentional changes or modifications, not expressly
approved by the party responsible for compliance, shall not be made.
Any such changes or modifications could void the user's authority to
operate the equipment. If necessary, the user should consult the dealer
or an experienced radio/television technician for corrective action. The
user may find the following booklet, prepared by the Federal Communi-
cations Commission, helpful: How to Identify and Resolve Radio-TV Inter-
ference Problems. This booklet is available from the U.S. Government
Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4.
WARNING: This is a Class A product. In a domestic environ-
ment, this product may cause radio interference, in which
case, the user may be required to take adequate measures.
Bosch Security Systems, Inc.

Safety Precautions

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This symbol indicates the presence of uninsulated
"dangerous voltage" within the product's enclo-
sure that can cause an electric shock.
This symbol indicates the presence of important
operating and maintenance (servicing) instruc-
tions in the literature accompanying the appli-
ance.
Installation should be performed by qualified ser-
vice personnel only in accordance with the
National Electrical Code or applicable local codes.
Power Disconnect. Units with or without ON-OFF
switches have power supplied to the unit when-
ever the power cord is inserted into the power
source; however, the unit is operational only when
the ON-OFF switch is in the ON position. The
power cord is the main power disconnect for all
units.
| en vii