Housing; Line Power And Video Signal Connection; Connections For U Suffix, F Suffix, And N Suffix; U (Twisted Pair) Suffix Connections - Bosch KBE-495V28-20N Instruction Manual

2 en | Installation
3.4

Housing

Feed the cabling from the housing foot through the mount. Attach the housing to the mount
using the two (2) 1/4-20 screws and washers provided in the hardware kit. For additional
information, refer to the LTC 9215/00 Mount Installation Manual and UHO-HBGS-10 Series
Housing Installation Manual.
3.5

Line Power and Video Signal Connection

The external video coax cable is equipped with a female BNC connector for transmission of
video. Route and connect video cable to the BNC connector. The external power cable is
provided to allow for necessary stripping/preparation by the installer. For additional
information, refer to the Installation Manuals included in the Instruction Booklet Packet.
Color
Green
White
Black
3.6

Connections for U Suffix, F Suffix, and N Suffix

The connections for models containing fiber optic, network, or twisted pair interfaces are
covered as follows:
3.6.1

U (Twisted Pair) Suffix Connections

These models include an unshielded twisted pair transmitter added to the standard
construction.
1.
2.
3.
4.
Figure 3.1 Connecting the UTP Cable to the Transmitter
Reference
1
2
5.
F01U065975 | 1.0 | 2007.04
Connection
Ground
24 V
24 V
Make all power connections in accordance with the KBE and KBN Series Instruction
Manual.
Pass the supplied orange string through the mounting foot of the camera housing and the
furnished mount. See Figure 3.2. A fitting may be used in the mounting foot if desired.
Attach the end of the string to the unshielded twisted pair (UTP) video cable and pull it
through the mount and the unused hole in the mounting foot of the camera housing as
shown in Figure 3.3.
Connect the UTP video cable to the the -VID+ pins on UTP transmitter. Observe polarity;
the video connection is polarity-sensitive. See Figure 3.1.
Description
Negative (-) terminal for twisted pair video lead
Positive (+) terminal for twisted pair video lead
Seal the hole in the mounting foot of the camera housing with RTV or an equivalent seal.
If a fitting was used in the mounting foot, apply the seal around the UTP cable before
tightening the fitting to prevent slippage.
Instruction Manual
KBE and KBN Series
Bosch Security Systems, Inc.