Using Learning; Learning Precautions - One for All OARP05S Owner's Manual

NOTE: If the DVD/VCR key did not blink twice after
entering the codes last digit, repeat steps 2 and 3 and
try entering the same code again. If you've located
a setup code that works for your combo device (for
example, a TV/VCR Combo) and a separate TV code
is also listed, you'll need to program this code into
the remote control to access volume control (see the
"Programming Device Control" section).
The device should turn off. If it does not respond,
repeat steps 2 and 3, trying each code listed for your
brand until you find one that works. If it still does not
5. For future reference, write down each working device
code in the boxes below:
Searching For Your Code
If your home entertainment device does not respond to the
OARP05S Cable Replacement Remote after trying all of the
codes listed for your brand, or if your brand is not listed at
all, try searching for your code.
5. Press and release the CH+ key continuously, then stop
NOTE: In the search mode, the remote control will send
IR codes from its library to the selected device, starting
with the most popular code first.
indicate that the code is saved.
NOTE: If the TV does not turn on during step 6, then
slowly press and release CH- to go back through the
codes, then press SETUP when the TV turns on.
they don't, repeat steps 1-4 above. In step 5, don't stop
CH+ until it turns off again.
NOTE: By default, the CH+/- keys change channels on
the CBL/SAT device regardless of what mode you're in.
So, you should only use these keys to test for CBL/SAT
device codes at this point.
8. To search for the codes of your other devices, repeat
steps 1 through 6, but substitute the appropriate key
device you're searching for.
Checking the Codes
If you have set up your remote control by searching for
your device code, you may need to find out which four-
digit code is operating your equipment.
3. To view the code for the first digit, press 1 once. Count
NOTE: If a code digit is 0, the selected mode key will not
blink.
4. Repeat step 3 three more times for the remaining
digits. Use 2 for the second digit, 3 for the third digit,
and 4 for the fourth digit. Finish writing down the code
5. To check for other device codes, repeat steps 1 through

Using Learning

The OARP05S Cable Replacement Remote includes a

Learning Precautions

for learning to work properly.
unique function for each mode.
on the code being learned.
multi-frequency types, some high frequency ones, and
other unusual formats.
light such as natural sunlight or energy-efficient
fluorescent lights.
NOTE: Please have your original remote controls handy
before programming learning.
Programming a Learned Key
NOTE: If more than 15 seconds pass between key
presses, the remote exits programming.
NOTE: If the LED displays one long flash instead,
either your batteries are low, or the OARP05S Cable
Replacement Remote has a memory fault.
3. Press the desired key on the OARP05S once to store the
feature to be learned.
the OARP05S Cable Replacement Remote to learn.
5. On the original remote, press and hold the key to be
turn off. Continue holding the key on the original
NOTE: If the LED displays one long blink, a learning
error has occurred. Try repeating this step again until
a successful capture occurs. If the function is still not
captured, press and hold SETUP to exit programming
and review the "Learning Precautions" earlier in this
section. If needed, also see "Troubleshooting" later in
this manual. After review, start programming again at
step 1.
blinks twice to exit programming.
2"