Dacor DYF42BNDI Installation Instructions Manual
Discovery built-in refrigerator 42 and 48 inch models
Hide thumbs
Also See for DYF42BNDI:
- Planning manual (5 pages) ,
- Use and care manual (20 pages) ,
- Use & care manual (19 pages)
Subscribe to Our Youtube Channel
Related Manuals for Dacor DYF42BNDI
Summary of Contents for Dacor DYF42BNDI
-
Page 1: Installation Instructions
Installation Instructions Discovery Built-In Refrigerator ™ 42 and 48 Inch Models: DYF42BNDI and DYF48BNDI Part No. 107310 Rev. A/W10565752... -
Page 2: Table Of Contents
® your Dacor dealer or the Dacor Customer Service Team. Phone: (800) 793-0093, extension 2813 (U.S.A. and Canada) For repairs to Dacor appliances under warranty call the Dacor Monday — Friday 6:00 . to 5:00 . Pacific Time Distinctive Service line. Whenever you call, have the model and Web site: www.dacor.com... -
Page 3: Refrigerator Safety
Refrigerator Safety Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER”... -
Page 4: Installation Requirements
Installation Requirements Tools and Parts Location Requirements IMPORTANT: Your Dacor refrigerator can be recessed in an opening between cabinets or installed at the end of a cabinet run using a side panel Installer: Leave these installation instructions with the ƒ... -
Page 5: Electrical Requirements
24" (61.0 cm) Min. (61.0 cm) min. Model Cutout Width A Dimension B 41½” (105.4 cm) to 10” DYF42BNDI 41¾” (106.0 cm) (25.4 cm) 47½” (120.7 cm) to 16” DYF48BNDI 47¾” (121.3 cm) (40.6 cm) NOTE: Flooring under refrigerator must be at same level as the... -
Page 6: Water Supply Requirements
A cold water supply with water pressure between 30 and 120 psi Model Tipping Radius A (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a DYF42BNDI 93” (236.2 cm) licensed, qualified plumber. DYF48BNDI 96” (243.8 cm) -
Page 7: Product Dimensions
(see following chart) *3¹⁄ ” (8.9 cm) Model Width B (Trim edge to trim edge) DYF42BNDI 42¼” (107.3 cm) * When the leveling legs are fully extended to 1¼” (3.2 cm) below DYF48BNDI 48¼” (122.6 cm) the rollers, add 1¹⁄... -
Page 8: Door Swing Dimensions
The location must permit both doors to open to a minimum of 90°. Allow 4½” (11.4 cm) minimum space between the side of the refrigerator and a corner wall. To adjust the door swing, see Adjust Doors. Model DYF42BNDI " ⁄ (32.1 cm) ⁄... - Page 9 Installation Requirements Door Panels and Cabinetry Clearance - Door Swing 110° The custom door panels and adjacent cabinetry must be designed so that there is sufficient clearance for the doors to swing open. If the refrigerator is to be installed close to the wall, see Door Swing 90° on following page. Refrigerator to Cabinetry Clearance Door swing 110°...
- Page 10 Installation Requirements Door Panels and Cabinetry Clearance - Door Swing 90° Refrigerator to Cabinetry Clearance Door swing 90° actual size Refrigerator Side Trim 1" (2.5 cm) ¾" (1.9 cm) ½" (1.3 cm) 90˚ Door Stop Position Cabinetry ¼" (6.35 mm) Hinge ½"...
-
Page 11: Custom Panels
Installation Requirements Custom Panels Overlay panel Spacer panel Spacer panel The custom overlay panels allow you to blend the exterior of your refrigerator into the overall kitchen décor, and to use custom " handles for additional design flexibility. (3.2 mm) The custom panels must have backer panels attached in order to mount them to the refrigerator. -
Page 12: Handles
” (1.5 mm) proper fasteners for the application. If using screws with thick heads, they must be countersunk into the panel before installing the handles. IMPORTANT: Dacor does not advise the use of single pull knobs. ⁄ ” (2.4 cm) NOTES: The dimensions shown are actual product dimensions and ƒ... -
Page 13: Installation Instructions
Model Reduced Tipping Radius lower the right-hand side of the DYF42BNDI 88½” (224.8 cm) refrigerator to the floor. DYF48BNDI 89¼” (226.7 cm) 5. Reassemble the trim and top grille after the dolly has been... -
Page 14: Install Anti-Tip Boards
Installation Instructions Install Anti-Tip Boards Connect Water Supply IMPORTANT: Read all directions before you begin. To avoid tipping during use, the solid soffit must be within 1” IMPORTANT: If you turn the refrigerator on before the water line ƒ (2.5 cm) maximum above the refrigerator. If the solid soffit is connected, turn the ice maker OFF. -
Page 15: Plug In Refrigerator
Installation Instructions Connect Water Supply (cont.) Plug in Refrigerator Connecting to Refrigerator WARNING Parts Supplied: ¼” to ¼” (6.4 mm to 6.4 mm) male to male coupling. 1” x 1” (2.5 cm x 2.5 cm) Possible water line locations Electrical Shock Hazard Plug into a grounded 3 prong outlet. -
Page 16: Level And Align Refrigerator
Installation Instructions Level and Align Refrigerator 3. Continue adjusting all of the leveling legs to raise the refrigerator until the top is within at least 1” (2.5 cm) of the top soffit. WARNING NOTE: If an anti-tip board has been used, adjust the leveling legs until the top of the refrigerator is within ¼”... -
Page 17: Custom Panel And Handle Installation
Custom Panels and Handles section. panel down slightly to lock it into Dacor is not responsible for customer installed molding or ƒ place. decorative panels that need to be removed or replaced to service the refrigerator. -
Page 18: Adjust Doors
Installation Instructions Adjust Doors 5. After adjusting, check the doors to make sure they are even at the top and bottom. If the doors are not even, continue to turn the bushing to adjust the door height. Door Height Adjustment 6. -
Page 19: Install Side Panel(S)
If the built-in area depth is 25” (63.5 cm) or more, the side panels can be installed inside the side trim or attached to the outside of the side trim. IMPORTANT: Dacor is not responsible for customer installed molding or decorative panels that need to be removed or replaced to service the refrigerator. -
Page 20: Complete Installation
Any questions or problems with this installation should be directed to your Dacor dealer or the Dacor Customer Service Team at (800) 793-0093 or visit our web site at www.dacor.com. - Page 22 Dacor ● 14425 Clark Avenue, City of Industry, CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www.dacor.com...
Need help?
Do you have a question about the DYF42BNDI and is the answer not in the manual?
Questions and answers