Advertisement
Ⅲ. Fitting instructions for camera
1
4
Fig.3
(A)
(B)
(C)
1. Unscrew the 3 captive Retaining Screws (C) and remove the Housing Cover (A) from
the Housing Base (B).
2. Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera Platform
(G) from the Housing Base (B).
3. Mount the Camera (H) onto the Platform (G) using the 1/4" UNC Screw (I) supplied, ensuring
that the Insulation Pad (J) is mounted between the Platform and the Camera. Always check
that the Camera is firmly attached to the Platform.
4. Connect the Camera power cable to the rear Terminal Block (E) through the
first Cable Conduit (D) referring to the circuit diagram shown in section IV. for the
terminal designations.
5. Connect the video cable to the Camera through the second Cable Conduit(D).
IMPORTANT NOTE:
ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN
DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER
AGAIN WHEN REASSEMBLING THE HOUSING.
Ⅳ. Wiring diagram
Fig.4 shows the internal wiring diagram of
DCS-50 for the window demister.
When necessary, a spare 6 way terminal
block is provided at the rear of the enclosure
for the camera and lens connections.
Circuit identified as follows:
TB.1
6 way terminal block
FTB.1
Fused terminal block
FS.1
3 Amp. Fuse
4
2
6
5
(C)
(E)
(D)
(G)
1 Camera mounting platform
2 Terminal block assembly
3 Cable conduits PGB13.5 x 2
4 Captive retainning 1/4" Screws x 3
3
5 Heater wires, Ground wire
6 Ground wire
(H)
(G)
(F)
(J)
(I)
Fig.4 Wiring diagram of DCS-50
ENCLOSURE BASE
CHASSIS EARTH
2
TB.1
1
2
3
4
5
6
N
E
L
FTB.1 FS.1
COVER EARTH
Advertisement
