Apm; Serial Port Configuration - Asus Z87-C User Manual

Realtek LAN Controller [Enabled]
[Enabled] Enables the Realtek
[Disabled] Disables the Realtek
The following item appears only when you set the Realtek LAN Controller to [Enabled].
Realtek PXE OPROM [Disabled]
Allows you to enable or disable the PXE OptionRom of the Realtek LAN controller.
Configuration options: [Enabled] [Disabled]

Serial Port Configuration

Allows you to set the parameters of the serial ports.
This item only functions only if there is a serial port (COM1) connector connected to the
motherboard.
Serial Port [Enabled]
Allows you to enable or disable the serial port.
Configuration options: [Disabled] [Enabled]
The following item appears only if you set the Serial Port to [Enabled].
Change Settings
Allows you to select an optimal setting for Super I/O device.
2.6.8

APM

ErP Ready [Disabled]
Allows you to switch off some power at S4+S5 or S5 to get the system ready for ErP
requirement. When set to [Enabled], all other PME options will be switched off.
Configuration options: [Disabled] [Enabled (S4+S5] [Enabled (S5)]
Restore AC Power Loss [Power Off]
[Power On] The system goes into ON state after an AC power loss.
[Power Off] The system goes into OFF state after an AC power loss.
[Last State] The system goes into either OFF or ON state, whatever the system state
was before the AC power loss.
Power On By PS/2 Keyboard [Disabled]
Allows you to turn on your computer by using the PS/2 keyboard.
Configuration options: [Disabled] [Enabled]
Chapter 2: BIOS information
LAN controller.
®
LAN controller.
®
2-33