Asus P I-P65UP8 CP6ND User Manual page 32

20. Main and Auxilliary AT Power Connectors (12-pin & 6-pin PWRCON)
This connector connects to a standard 5 Volt power supply. To connect the leads
from the power supply, ensure first that the power supply is not plugged. Most
power supplies provide two plugs (P8 and P9), each containing six wires, two of
which are black. An auxilliary connector (P10) is provided in case the power
supplied through the main connectors are insufficient. Orient the main connec-
tors so that the black wires are located in the middle.
AT Power Connector
Using a slight angle, align the plastic guide pins on the lead to their receptacles
on the connector. Once aligned, press the lead onto the connector until the lead
locks into place.
21. ATX Power Supply Connector (20-pin ATXPWR)
This connector connects to a ATX power supply. The plug from the power
supply will only insert in one orientation because of the different hole sizes.
Find the proper orientation and push down firmly making sure that the pins are
aligned.
IMPORTANT: Be sure that the ATX power supply can take at least 10mAmp
load on the 5volt standby lead (5VSB). You may experience difficulty in
powering on your system without this.
ATX Power Connector
32
III. INSTALLATION
+5Volts
-12Volts
-5Volts
Power Connector
on Motherboard
+12.0 Volts
+5V Standby
Power Good
Ground
5.0 Volts
Ground
+5.0 Volts
Ground
+3.3 Volts
+3.3 Volts
Power Connector
on Motherboard
ASUS P/I-P65UP8 User's Manual
PG
ORG
RED
+12Volts
YLW
P8
BLU
BLK
BLK
Ground
BLK
BLK
P9 WHT
RED
+5Volts RED
RED
RED
+5Volts
RED
RED
P10
BLK
Ground
BLK
BLK
Power Plugs from
Power Supply
+5.0 Volts
+5.0 Volts
-5.0 Volts
Ground
Ground
Ground
Power Supply On
Ground
-12.0 Volts
+3.3 Volts