Asus P I-P55TP4N User Manual page 29

III. INSTALLATION
9. Turbo LED lead (CON1)
The motherboard's turbo function is always on. The turbo LED con-
nection is labeled here but the LED will remain constantly lit while the
system power is on. You may wish to connect the Power LED from
the system case to this lead. See the figure below.
10. SMI suspend switch lead (CON1)
This allows the user to manually place the system into a suspend mode
or "Green" mode where system activity will be instantly decreased to
save electricity and expand the life of certain components when the
system is not in use. This 2-pin connector (see the figure below) con-
nects to the case-mounted suspend switch. If you do not have a switch
for the connector, you may use the "Turbo Switch" since it does not
have a function. SMI is activated when it detects a short to open mo-
ment and therefore leaving it shorted will not cause any problems. May
require one or two pushes depending on the position of the switch.
Wake-up can be controlled by settings in the BIOS but the keyboard
will always allow wake-up (the SMI lead cannot wake-up the system).
If you want to use this connector, "Suspend Switch" in the POWER
MANAGEMENT SETUP of the BIOS software should be on the de-
fault setting of Enable (see page 38).
11. Reset switch lead (CON1)
This 2-pin connector connects to the case-mounted reset switch for
rebooting your computer without having to turn off your power switch
This is a preferred method of rebooting in order to prolong the life of
the system's power supply. See the figure below.
12. Keyboard lock switch lead (CON1)
This 5-pin connector connects to the case-mounted key switch for lock-
ing the keyboard for security purposes. See the figure below.
13. Speaker connector (CON1)
This 4-pin connector connects to the case-mounted speaker.
Turbo or
Power LED
SMI Lead
Reset SW
System Case Connections
P/I-P55TP4N User's Manual
+5V
Power LED &
NC
+5V
GND
GND
LOCK
Keyboard Lock
GND
GND
+5V
Speaker
GND
Connector
GND
SPKR
GND
23