Asus P I-P55TP4N User Manual page 27

III. INSTALLATION
5. Floppy drive connector (34-pin block )
This connector supports the provided floppy drive ribbon cable.
After connecting the single end to the board, connect the two plugs
on the other end to the floppy drives.
6. Power connector (12-pin block)
This connector connects to a standard 5 Volt power supply. To connect
the leads from the power supply, ensure first that the power supply is
not plugged. Most power supplies provide two plugs (P8 and P9),
each containing six wires, two of which are black. Orient the connec-
tors so that the black wires are located in the middle.
Using a slight angle, align the plastic guide pins on the lead to their
receptacles on the connector. Once aligned, press the lead onto the
connector until the lead locks into place.
Pin 1
Floppy Drive Connector
+5V
GND
+12V
PG
Power Connector
on Motherboard
P/I-P55TP4N User's Manual
RED
RED
RED
-5V
WHT
BLK
BLK
BLK
BLK
-12V BLU
YLW
RED
+5V
ORG
Power Plugs from
Power Supply
21