Intel H61 Serial Ata 3.0Gb/S Connectors; Usb Device Wake-Up - Asus H61M-K User Manual

3. Intel H61 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~4)
®
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via
Serial ATA 3.0 Gb/s signal cables.
H61M-K
H61M-K Intel
• You must install Windows
hard disk drives.
• Due to H61 Chipset limitation, AHCI Mode only works on Windows
7. Please use IDE Mode on Windows
• To configure the SATA type in BIOS, click Advanced Mode > Advanced tab > SATA
Configuration > SATA Mode Selection. See section 2.5.3 SATA Configuration for
details.
• When using hot-plug and NCQ on Windows
Selection item in the BIOS to [AHCI]. See section 2.5.3 SATA Configuration for
details.
4. USB device wake-up (3-pin PS2_USBPW1~4; USBPW5~8)
Set this jumper to +5V to wake up the computer from S1 sleep mode (CPU stopped,
DRAM refreshed, system running in low power mode) using the connected USB
devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU,
DRAM in slow refresh, power supply in reduced power mode).
H61M-K
H61M-K USB Device Wake Up
• The USB device wake-up feature requires a power supply that can provide 500mA on
the +5VSB lead for each USB port; otherwise, the system would not power up.
• The total current consumed must NOT exceed the power supply capability (+5VSB)
whether under normal condition or in sleep mode.
ASUS H61M-K
SATA3G_2
GND
RSATA_RXP2
RSATA_RXN2
GND
RSATA_TXN2
RSATA_TXP2
GND
SATA3G_4
GND
RSATA_RXP4
RSATA_RXN4
GND
RSATA_TXN4
RSATA_TXP4
GND
SATA 3.0Gb/s connectors
®
XP Service Pack 3 or later version before using Serial ATA
®
PS2_USBPW1-4
1 2
+5V
(Default)
USBPW5-8
1 2
+5V
(Default)
SATA3G_1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXN1
RSATA_RXP1
GND
SATA3G_3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXN3
RSATA_RXP3
GND
XP.
®
Vista / Windows
®
2 3
+5VSB
2 3
+5VSB
Vista / Windows
® ®
7, set the SATA Mode
®
1-27