FujiFilm @xia ix-100 User Manual page 70

Problem
The image is blurred.
Images of subjects shot
in close-up mode are too
bright.
Nothing happens when
you use the camera
buttons and switch.
There is no picture on TV
I cannot format the
SmartMedia.
The PC does
recognize the camera.
70
h The camera or subject was moving when
the shot was taken.
h You photographed a distant subject with
the p close-up mode.
h The flash fired in close-up photography.
h Camera malfunctions.
h The batteries are exhausted.
h The TV input is incorrect.
h The SmartMedia is write-protected.
not
h Connect the camera to the PC with the
USB cable before installing the software.
Cause Remedy
h Use the tripod, or set to the flash mode.
h Set the shooting distance selector
switch to j normal mode.
h Set to the s flash-off mode.
h Remove the batteries, re-insert them
and try again.
h Replace the new alkaline batteries.
h Set to TV input to "video".
h Remove the write-protection (Peel off
the write-protect sticker).
h Connect the camera to the PC with the
USB cable and select [My Computer] /
[Control Panel] / [System] / [Device
Manager]. In the Device Manager
window, delete [Composite USB device]
or [Unknown device] in [Other devices].
Then disconnect the camera and install
the software before reconnecting the
camera to the PC.
h Connect the camera directly to the PC
using the USB cable, not via a USB
hub.
h Disconnect the other USB devices
conneted to the PC.