Charging The Battery; Using The Ac Power Adapter; Switching On And Off - FujiFilm FinePixF402 Owner's Manual

CHARGING THE BATTERY

DC IN 5V socket
Check that the camera is switched off. Plug the
AC power adapter connector into the DC IN 5V
socket on the camera and then plug the adapter
itself into the main power outlet.
The self timer lamp lights (blue) and battery
charging begins. When charging is completed,
the self-timer lamp switches off.
A fully discharged battery takes roughly 2 hours
to fully recharge (at an ambient temperature of
+21°C to +25°C (+70°F to +77°F)).
14

Using the AC Power Adapter

Use the AC power adapter to avoid losing power
at inconvenient times, such as when you are
downloading photographed images to your
computer. Using the AC power adapter also
allows you to take pictures and play back images
without worrying about depleting the battery.
hCompatible AC power adapters
AC-5VS/AC-5VHS/AC-5VH
G
!
Use only the FUJIFILM products listed above.
G
!
See P.111 for notes on using the AC power adapter.
G
!
Only connect or disconnect the AC power adapter when
the camera is switched off.
Connecting or disconnecting the AC power adapter while
the camera is switched on temporarily interrupts the
power supply to the camera, so that images or movies
being shot at the time are not recorded. Failing to switch
the camera off first can also result in damage to the xD-
Picture Card or malfunctions during PC connection.
G
!
Charging times increase at low temperatures.
G
!
If the self-timer lamp blinks during charging, a charging
error has occurred and the battery cannot be charged. If
this occurs, see P.117.
G
!
Switching the camera on during charging interrupts the
charging.
G
!
You can charge the battery more quickly by using the
BC-65 Battery Charger (sold separately) (➡P.106).
G
!
The shape of the plug and socket-outlet depends on the
country of use.

SWITCHING ON AND OFF

1
ON OFF
Slide the POWER switch to turn the camera on
and off. When you switch the camera on, the
viewfinder lamp lights (green) and the self timer
lamp lights for 5 seconds.
N N
Power Save Function
When enabled, this function switches the LCD monitor
off to reduce power consumption if the camera is not
used for approximately 30 seconds (➡P.74). If the
camera is then left unused for a further period (2
minutes or 5 minutes), the Power Save function
automatically switches the camera off. To switch the
camera back on, slide the Power switch to the side to
turn the camera off briefly and then turn it back on.
✽ See P.19 for information on selecting the language.
2
ＤＡＴＥ／ＴＩＭＥ ＮＯＴ ＳＥＴ ＤＡＴＥ／ＴＩＭＥ ＮＯＴ ＳＥＴ
ＯＫ ＳＥＴ ＳＥＴ ＢＡＣＫ ＮＯ
When you first switch the camera on, the date is
cleared. Press the "MENU/OK" button to set the
date and time. Refer to the next page for
information on setting the date and time.
G
!
To set the date and time later, press the "BACK" button.
G
!
If you do not set the date and time, this confirmation
screen will appear each time you switch the camera on.
G
!
If you load the battery while the camera's POWER
switch is set to ON, the viewfinder lamp/self timer lamp
lights briefly. This is normal and does not indicate a fault.
1
15