ASROCK 960GC-GS FX User Manual page 23

Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB4_5)
(see p.12 No. 18)
(9-pin USB6_7)
(see p.12 No. 17)
(9-pin USB8_9)
(see p.12 No. 16)
Front Panel Audio Header
(9-pin HD_AUDIO1)
(see p.12 No. 25)
1. High Definition Audio supports Jack Sensing, but the panel wire on
the chassis must support HDA to function correctly. Please follow the
instruction in our manual and chassis manual to install your system.
2. If you use AC'97 audio panel, please install it to the front panel audio
header as below:
A. Connect Mic_IN (MIC) to MIC2_L.
B. Connect Audio_R (RIN) to OUT2_R and Audio_L (LIN) to OUT2_L.
C. Connect Ground (GND) to Ground (GND).
D. MIC_RET and OUT_RET are for HD audio panel only. You don't
need to connect them for AC'97 audio panel.
E. To activate the front mic.
For Windows
Select "Mixer". Select "Recorder". Then click "FrontMic".
USB_PWR
P-4
P+4
GND
DUMMY
GND
P+5
P-5
USB_PWR
USB_PWR
P-9
P+9
GND
DUMMY
1
GND
P+8
P-8
USB_PWR
GND
PRESENCE#
MIC_RET
OUT_RET
1
OUT2_L
J_SENSE
OUT2_R
MIC2_R
MIC2_L
®
XP / XP 64-bit OS:
23
Either end of the SATA data
cable can be connected to the
SATA2 hard disk or the SATA2
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there
are three USB 2.0 headers on
this motherboard. Each USB 2.0
header can support two USB
2.0 ports.
This is an interface for the front
panel audio cable that allows
convenient connection and
control of audio devices.