Zone Rename; Trigger Out - Marantz SR5008 Owner's Manual

Contents
2 Volume Limit
Make a setting for maximum volume.
60 (–20dB) / 70 (–10dB) / 80 (0dB) (Default : 70 (–10dB))
Off : Do not set a maximum volume.
2 Power On Volume
Define the volume setting that is active when the power is turned on.
Last (Default) : Use the memorized setting from the last session.
Mute : Always mute when power is turned on.
1 – 98 (–79dB – 18dB) : The volume is adjusted to the set level.
2 Mute Level
Set the amount of attenuation when muting is on.
Full (Default) : The sound is muted entirely.
–40dB : The sound is attenuated by 40 dB down.
–20dB : The sound is attenuated by 20 dB down.
%
• This can be set when "Volume Level" (vpage 177) is set to "Variable".
Front panel Display
Connections Playback
Rear panel
Settings

Zone Rename

Change the display title of each zone to one you prefer.
MAIN ZONE / ZONE2
Set Defaults : The input source name is returned to the default setting.
%
• Up to 10 characters can be input.
• For character input, see page 138.

Trigger Out

Selects when to activate trigger out.
For details about how to connect the DC OUT jacks, see "DC OUT jack"
(vpage 49).
n When setting for zone (MAIN ZONE / ZONE2)
Trigger out is activated through linkage to the power of the zone set
to "On".
n When setting for input source
Activate trigger out when the input source set to "On" is selected.
On : Activate trigger on this mode.
– – – : Do not activate trigger on this mode.
178
Remote
Tips Appendix
Index