Wi-Fi Protected Setup (Wps); Using Wps To Connect To A Network - Epson XP-410 Manual

7. Use your computer or wireless device to select the Wi-Fi network name (SSID) displayed on the
LCD screen, then enter the password shown.
8. Press the OK button to exit.
You see either an AP or Direct connection symbol on the LCD screen and should be able to print
directly to your product from your computer or device.
Note: If the AP or Direct connection symbol is not displayed on the LCD screen, Wi-Fi Direct mode
is not enabled. Repeat these steps to try again.
Parent topic:

Wi-Fi Protected Setup (WPS)

If your network uses a WPS-enabled wireless router or access point, you can quickly connect your
product to the network using Wi-Fi Protected Setup (WPS).
Note: To check if your router is WPS-enabled, look for a button labeled WPS on your router or access
point. If there is no hardware button, there may be a virtual WPS button in the software for the device.
Check your network product documentation for details.

Using WPS to Connect to a Network

Parent topic:
Using WPS to Connect to a Network
If you have a WPS-enabled wireless router or access point, you can use Wi-Fi Protected Setup (WPS) to
connect your product to the network.
1. Press the WPS button on your router.
2. On the product, press the
Wi-Fi Direct Mode Setup
Wi-Fi Networking
home button, if necessary.
33