Table of Contents
Advertisement
Power button board
Description
Power button board (includes cable)
Before removing the power button board, remove the following components:
1.
Battery (see
2.
Service access cover (see
3.
Hard drive (See
4.
Optical drive (see
5.
WLAN module (see
6.
Memory module (see
7.
Keyboard (see
8.
Top cover (see
Remove the power button board:
1.
Position the top cover upside down, with the rear edge toward you.
2.
Remove the Phillips 3.0×2.0 screw (1) that secures the power button board to the top cover.
3.
Lift up and remove the power button board (2).
Reverse this procedure to install the power button board.
ENWW
Battery on page
44)
Service access cover on page
Hard drive on page
Optical drive on page
WLAN module on page
Memory module on page
Keyboard on page
53)
Top cover on page
56)
45)
46)
48)
50).
52)
Component replacement procedures
Spare part number
641144-001
59
Advertisement
Table of Contents
