HP OmniBook 800 - Notebook PC User Manual page 72

*To contact Hewlett-Packard, see the Service and Support booklet or the
OmniBook Support icon in Program Manager (OmniBook Library group).
If a floppy drive doesn't work
Check the cable connections.
If you're not using an OmniBook floppy drive, you may need to install
and activate its driver software—see the floppy drive instructions.
If a drive you specify isn't found
For a plug-in card, make sure it's working properly—see
doesn't work properly in a card
If a card's write-protect switch doesn't work
Reinsert the card after you change its switch setting.
If disk access is unreliable
If you used Microsoft DriveSpace to compress drive C, you should turn
off 32-bit file access if you're copying files to or from another
compressed drive.
If files on drive C become damaged
If possible, exit Windows and type scandisk or chkdsk c: /f . This may
repair the damage.
If possible, restore the damaged files from backup disks.
If the OmniBook has problems rebooting from drive C, see
OmniBook doesn't reboot
If you're using DriveSpace on removable disks
Floppy disks and PC disks are removable disks.
If you have used Microsoft DriveSpace compression to compress drive
C and you want to use compressed removable disks, you must turn off
32-bit file access for reliable operation. In Control Panel, use the
Enhanced icon, then choose Virtual Memory and Change. (Drive C
compression, removable-disk compression, and 32-bit file access should
not be active at the same time.)
If you want to use Microsoft DriveSpace compression on removable
disks without compressing drive C, use the following steps:
To turn on DriveSpace for only removable drives:
1. Exit Windows.
2. Type dscopy and press ENTER.
3. Press CTRL+ALT+DEL.
To turn off DriveSpace:
4. Exit Windows.
5. Type dsdel and press ENTER.
slot".
successfully".
"If a PC card
"If the
72