HP OmniBook 800 - Notebook PC User Manual page 58

8. If the ribbon cables are no longer tucked into the frame, then push them
back into the recessed openings with a paper clip, as shown below. Re-
insert the keyboard by engaging the four front tabs on the keyboard into
the four slots in the computer frame, pressing down on the keyboard as
you insert the tabs. Make sure the ribbon cables slide into the recessed
openings and do not extend under the keyboard.
9. Close the OmniBook, turn it over, and re-insert the five screws removed
in step 3. Do not over-tighten the screws—screw just until you feel
resistance.
10. Insert the battery. Connect the ac adapter.
11. Press the reset button.
12. Install Windows and the original software on the new drive C using the
Recovery CD-ROM—check the README file for instructions. (If you are
using an operating system other than Windows95, you need to re-install
the operating system from your own source, then load the OmniBook-
specific software, as explained in the Getting Started manual.)
13. Restore the files you backed up from the old drive C:
Use the same software to restore your files that you used to back them
up in step 1.
58