Dell Force10 MXL Blade Getting Started Manual page 24

This is the configuration information that has been
collected:
SNMP Interface = "mxl1"@1.1.1.1
User Account setup = root
Password = ******
Out-of-band IP address = 192.168.2.1 255.255.255.0
VLAN1 Router Interface IP = 2.2.2.80 255.255.255.0
Default Gateway = 192.168.2.0
If the information is correct, please enter (Y) to
save the configuration.
If the information is incorrect, enter (N) to discard
the configuration and restart the wizard: [Y/N] y
Thank you for using the Dell Easy Setup Wizard. You
will now enter CLI mode.
Applying Interface configuration, please wait ...
FTOS>
NOTE:
If you do not save the initial configuration settings, they will be lost at the
next switch reboot and the Setup Wizard will be invoked. To save the initial
configuration to the startup configuration, enter the following commands at the CLI
prompt on the attached console:
FTOS> enable
FTOS# write memory
24
Installing and Configuring the Switch