Rtc Battery - HP ENVY dv7-7200 Maintenance And Service Manual

RTC battery

Description
RTC battery (includes cable and double-sided tape)
Before removing the RTC battery, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
5. Remove the service cover (see
Remove the RTC battery:
1. Disconnect the RTC battery cable (1) from the system board.
2. Release the RTC battery (2) from the cavity in the base enclosure.
NOTE:
may be required to release the RTC battery from the base enclosure.
3. Remove the RTC battery.
Reverse this procedure to install the RTC battery.
52 Chapter 4 Removal and replacement procedures
Battery on page
Hard drive on page
The RTC battery is attached to the base enclosure with double-sided tape. Firm pressure
47).
48).
Spare part number
682091-001