Dell PowerConnect W-Series FIPS Supplement Manual page 14

Series; the table below describes the states and LED behaviors associated with use of the media eject
button.
Table 4 Media Eject Button LED Behavior
Initial State
NAS Media Operational
NAS Media Unmounted
Operational
Operating with NAS
Media un-mounted
Standby
The behavior of the Power, Status and port LEDs is described in the table below:
Table 5 Aruba 650 Series LED Status Indicators
LED
Power
Status
1000Base-X Ports (SFP)
14 | The Aruba 620 and 650 Mobility Controllers
LED State Action
Green-solid Press and hold
media eject button
for 1 to 5 seconds
only
Amber-solid Press and hold
media eject button
for 1 to 5 seconds
only
Green-solid Press and hold
media eject button
for more than 5
seconds only
Amber-solid Press and hold
media eject button
for more than 5
seconds only
Red-solid Press media eject
button
Label Function
POWER Input Power Status Indicator
STATUS Module Status Indicator
LNK/ACT Link Status Indicator
Status LED
Amber-flashing
Amber-flashing
Red-flashing
Red-flashing
Amber-flashing
Indicator
On (Solid Green)
Off
On (Solid Green)
On (Solid Red)
On (Solid Amber)
Off
On (Solid Green)
On (Flashing Green)
Off
Aruba 620, 650 and Dell W-620, W-650 | FIPS 140-2 Level 2 Release Supplement
LED Action
Function
Completed
Un-mount all NAS Amber-solid
media
Mount all attached Green-solid
NAS devices, and
return to fully
functional
operation
Controller goes Red-solid
into Standby
Controller goes Red-solid
into Standby
Controller wake-up Green-solid
Status
Power on
No Power
Device is operational
Device failed or is in Standby
Device is loading software
No power
Link has been established
Port is transmitting or receiving
data
No link on port