FujiFilm FinePix F40fd Owner's Manual page 140

Power Supply and Battery
Notes on Using the Battery Charger
Use with the following power supply cord set:
Cord: UL Listed, Type SPT-2, No.18 AWG, rated 300V,
10A, minimum 4 ft (1.2m), maximum 10 ft (3m) long.
One end terminates in a molded-on, parallel-blade, (non-
polarized) attachment plug with a 7A, 125V (NEMA 1-
15P) configuration.
• The battery and battery charger themselves will
become warm due to the power stored inside them. This
is normal and does not indicate a fault. Wherever
possible, use the battery charger in a well-ventilated
location.
• There may be vibration noises from inside the battery
charger during use. This is normal and does not indicate
a fault.
• Do not use the battery charger to charge batteries other
than rechargeable battery NP-70.
• The battery charger could cause interference if placed
close to a radio during charging. In this event, move the
radio and charger further apart.
• Do not leave the battery charger in the following types
of locations:
• Extremely humidity or high temperatures, such as
close to a heating appliance or in direct sunlight
• Places with strong vibration
• In very dusty places
• The battery charger accepts input voltages of 100-240
V AC at 50 or 60 Hz and can be used all over the world.
However, the shape of the plug and socket-outlet
depends on the country of use. Consult your travel
agent for details.
140
Z Battery Charger BC-70 Specifications
Rated input 110-240 V AC, 50/60 Hz
Input capacity 110-240 V -0.2 A
Rated output 4.2 V DC, 800 mA
Applicable Rechargeable Battery
batteries NP-70
Charging time Approx. 120 minutes
Dimensions 53 mm × 80 mm × 24 mm
(2.1 in. × 3.1 in. × 1.0 in.)
(L × W × D)
Mass (Weight) Approx. 55 g (1.9 oz.)
(excluding batteries)
Operating 0°C to + 40°C
temperatures (+ 32°F to + 104°F)