Operating Instructions - RBI LCD Series Installation & Operation Manual

Page 26
Demand Satisfi ed:
1. When the demand for heat is satisfied the low
operator switch will open, de-energizing relays R2,
R2R, R8, R9, TD1, TD3, TD4, TD6, the FSM, and
the pilot, main and safety solenoid valves. The pilot
and main fl ames are extinguished.
2. The blower delay timer TD3 starts the 80 second
post-purge timing. The blower(s) shut(s) off when
TD3 times out.
3. The pump delay timer TD4 starts the post-purge
timing. The pump(s) remain on for 0.1 to 10 minutes
then shut(s) off when TD4 times out.
High Limit, Low Water Flow, Low Gas Pressure, High
Gas Pressure, Power Venter Interlock Faults
1. Electrical power to the gas valves, blower(s) and
power venter will be interrupted if any safety is
tripped.
2. The manual reset high limit can be reset by
depressing the reset button on the left jacket
panel.
Low Air (Blocked Flue/Air Inlet)
• The pressure switches will monitor blower airfl ow.
• Air monitoring will begin at pre-purge. If a low air
condition is present, power will not be supplied to the
FSM. The blower(s) will remain on.

OPERATING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE OPERATING
POUR VOTRE SÉCURITÉ LISEZ AVANT DE METTRE
EN MARCHE
A. This appliance is equipped with an ignition device
which automatically lights the pilot. Do not try to light
the pilot by hand.
Cet appareil est muni d'un dispositif d'allumage qui
allume automatiquement la veilleuse. Ne tentez pas
d'allumer la veilleuse manuellement.
B. BEFORE OPERATING smell all around the
appliance area for gas. Be sure to smell next to the
fl oor because some gas is heavier than air and will
settle on the fl oor.
LCD INSTALLATION AND OPERATION INSTRUCTIONS
DANGER: Propane gas may not always be
detected by smell. Propane gas is heavier than
air and can collect in low areas.
Propane gas can ignite or explode if an ignition
source is present and result in death, serious
injury and property damage!
FOR YOUR SAFETY
• Have only qualifi ed licensed professionals install,
service and maintain this appliance and your gas
system in accordance with all applicable codes.
• Install a nationally listed combustible gas
detector(s) in your home.
• If you suspect a leak:
1. Have everyone leave the building immediately.
2. Do not attempt to light any appliance.
3. Do not touch any electrical or electronic switches
in the building.
4. Do not use any phone in the building.
5. Call your gas supplier from a phone outside of
the building.
6. If you cannot reach your gas supplier call the fi re
department.
AVANT DE FAIRE FONCTIONNER, renifl ez tout autour
de l'appareil pour déceler une odeur de gaz. Renifl ez
près du plancher, car certains gaz sont plus lourds que
l'air et peuvent s'accumuler au niveau du sol.
QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ:
• Ne pas tenter d'allumer d'appareil.
• Ne touchez à aucun interrupteur; ne pas vous servir
des téléphones se trouvant dans le bâtiment.
• Appelez immédiatement votre fournisseur de gaz
depuis un voisin. Suives les instructions du
fournisseur.
• Si vous ne pouvez rejoindre le fournisseur, appelez
le service de incendies.
C. Do not use this appliance if any part has been
under water. Immediately call a qualifi ed service
technician to inspect the appliance and to replace
any part of the control system and any gas control
that has been under water.
N'utilisez pas cet appareil s'il a été plongé dans
l'eau, même par tiellement. Faites inspecter
l'appareil par un tecnicien qualifié et remplacez
toute par tie du système de contrôle et toute
commande qui ont été plongés dans l'eau.
CAUTION: To prevent being burned, stand clear of
the boiler during ignition and do not touch any hot
metal parts.