Python 900 Owner's Manual page 44

note: Owner Recognition cannot be programmed with-
out a Directed Bitwriter
Check with your dealer for more information.
r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
This Directed system will store its current state to non-volatile
memory. If power is lost and then reconnected, the system will
recall the stored state from memory. This means if the unit is in
Valet Mode and the battery is disconnected for any reason, such
as servicing the car, when the battery is reconnected the unit will
still be in Valet Mode. This applies to all states of the system
including arm, disarm, VRS
p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet
operation has been performed. This lowers the current draw to
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤ Power Saver when the system is armed: After the system has
been armed for 24 hours, the in-vehicle LED will flash at
half its normal rate, decreasing the system's current draw.
➤ Power Saver in Valet
Mode the in-vehicle LED illuminates steadily. If the vehicle
© 2005 directed electronics, inc.
®
and the necessary software.
® , and Valet Mode.
Mode, after a period of time in which no
®
Mode: When the system enters Valet
® ®
45