Table of Contents
Advertisement
NOTE: If the remote start is on the parking lights will turn off then flash
2-times before returning to their normal output and the defogger out-
put, if active, will cease.
To turn the rear defogger output ON:
1. Simultaneously press & release the
tons on the remote control.
2. The lights will flash 3 times.
3. The rear defogger output will once again activate when the
vehicle is remote started.
NOTE: If the remote start is on the lights will turn off then flash 3-times
before returning to their normal output and the defogger output will
activate as programmed.
Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is
useful for occasions when you wish to exit and lock the vehicle for
short periods of time, but would like to leave the motor running
and the climate controls on.
To perform Valet Take-Over:
1.
Before turning off the engine, press and release
transmitter twice (or press and release the optional momen-
tary switch twice).
2.
Turn the ignition key to the OFF position. (The engine will
stay running.)
3.
Once the vehicle has started, it will run for the pre-program-
24
+
2006 Directed Electronics—all rights reserved
©
+
but-
on the
Advertisement
Table of Contents
