Power Acoustik PTID-8940NRT Operating Manual page 24

Auto Antenna Control
Connect the auto antenna control wire AUTO_ANT (see Wiring Diagram); the antenna
will lift when the unit startup; it will descend when the unit turnoff.
Brake Control
It is necessary to connect the Brake Control wire to the Hand-brake switch of the car.
While driving, the TFT monitor will display the alarm picture (see as follows) in order to
ensure the safety.
Under the Rear View Mode, the Brake Control function is no effective.
Protection of the TFT Monitor
During the movement of the TFT monitor, if it is halted by force, then the unit will begin
self-protection to prevent from any damage on the motorized mechanical structure.
Press the [OPEN] button or shut down the ACC and then restart, the TFT monitor will
act as the follow list to recover; if not, then please consult with an authorized service
center.
Halt
While extending
While retraction
While turning
upward
While turning
downward
Self-protection
Retraction
Stop at the halt place and
retract after 3 seconds
Turning downward and
retraction
Stop at the halt place
Press the [OPEN]
button
Extending
Extending
Extending
Turning downward
and retract ion
23
Shut down the
ACC and restart
Retraction
Retraction
Turning downward
and retract ion
Turning downward
and retract ion