Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Power Acoustik AWB-10
Summary of Contents for Power Acoustik AWB-10
- Page 1 POWERED SUBWOOFER SYSTEM...
-
Page 2: Your New Subwoofer
POWER ACUOUSTIK YOUR NEW SUBWOOFER..* RCA INPUT/HIGH LEVEL INPUT * P.W.M MOSFET POWER SUPPLY * SOFT DELYED REMOTE TURN-ON * DUAL COLOR INDICATOR L.E.D (POWER/GREEN & PROTECTION/RED) * REMOTE CONTROL FOR SUBWOOFER LEVEL * CONTROL: GAIN, PHASE, LPF, BASS BOOST * PROTECTION CIRCUIT: THERMAL PROTECTION CIRCUIT SHORT PROTECTION CIRCUIT OVERLOAD PROTECTION CIRCUIT... - Page 3 SUBWOOFER MOUNTING LOCATION This INSTALLING THE REMOTE Select a mounting location that allows easy access to the control while driving. Using the subwoofer level control(remote) as a template, mark and drill holes in the mounting surface. UNDER DECK MOUNTING (Suggestion of the remote placement)
-
Page 4: Connection And Operation
CONNECTION AND OPERATION POWER INPUT TERMINAL (CONNECTING THE POWER Fig. 1) - Page 5 CONNECTING THE POWER (Fig.1) Vehicle's chassis ground POWER INPUT To Power antenna FUSE The amplifier is equipped with a plug-in auto fuse protecting set against fault conditions. Do not use a fuse with a higher value and never bridge the fuse over. L.E.D The L.E.D is a dual color indicator, when the +12v and REM +12 volt power both switch on, The L.E.D illuminated green.
- Page 6 REMOTE (CONNECTING THE SUBWOOFER TO THE REMOTE Fig. 2) Use remote wire(accessory) connect "REMOTE SOCKET" to the remote (accessory), the remote is for subwoofer level control. Fig. 2 Connecting the subwoofer to remote Rear view of remote controller LINE IN(LOW LEVEL INPUT) Use a pair of shielded stereo audio cable with RCA type jack connect your receiver's "LOW LEVEL OUT"...
- Page 7 HI INPUT( HIGH LEVEL INPUT) HI INPUT CONNECTOR WIRE(ACCESSORY) White/Black L+ White L- 1= White, Channel L- 2=Black, GND Grey/Black R+ Grey R- 3=White/Black, Channel L+ 4=Grey, Channel R- 5=Grey/Black, Channel R+ Black, GND PHASE The PHASE switch is used for changing woofer phase, set switch from "0 "...
- Page 8 ITEM 800W <0.4% >90% 20Hz TO 150Hz 110mV INPUT SENSITIVITY HIGH 0.5V 50Hz -150Hz Adjustable BASS BOOST 0dB-12dB 10 INCH DIMENSIONS(L x W x H) 400 x 240 x310 mm NET WEIGHT 8.8kg Note: SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE. Is volume minimum? SOUND Input level control...
Need help?
Do you have a question about the AWB-10 and is the answer not in the manual?
Questions and answers