Operating Instructions VACUUM CLEANER ❈ Before operating this unit, please read the instructions carefully. ❈ Indoor use only. Register your product at www.samsung.com/global/register DJ68-00321M REV(0.4)
IMPORTANT SAFEGUARDS 1. Read all instructions carefully. Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate on the bottom of the cleaner. 2. WARNING: Do not use the vacuum cleaner when rug or floor is wet. Do not use to suck up water.
OPERATING THE CLEANER 2-1 ON/OFF SWITCH 2-2 POWER CORD NOTE When removing the plug from the electrical outlet, grasp the plug, not the cord. 2-3 POWER CONTROL (INFRARED CONTROL) 1) REMOTE CONTROL TYPE - HOSE 1. Vacuum cleaner ON/OFF Press the ON/OFF button to operate the vacuum cleaner.
2) BODY-CONTROL TYPE - HOSE - BODY To reduce suction for cleaning draperies, MIN = For delicate surface e.g. net curtains. small rugs, and other light fabrics, pull the MAX = For hard floors and heavily soiled carpets. tap air until the hole is open. 2-4 HOW TO USE AND MAINTAIN THE ACCESSORIES Features may vary according to model.
OPTION Carpet Cleaning Floor Cleaning Remove waste matter completely if the inlet is blocked. Adjust the inlet lever according to the floor surface. OPTION Vacuum dust in wide area at once Remove waste matter completely if the inlet is blocked. OPTION Frequent vacuuming of hair or pet fur may cause a falling-off of the rotation due to matters tangled around the drum.
EMPTYING THE DUST BIN Once dust reaches the dust full Take the dust bin out by Separate the dust mark, or once the dust pressing the button. bin cover. full light is on, empty the dust bin. CLICK Throw away dust in Close the dust bin cover.
CLEANING THE DUST PACK 4-1. WHEN TO CLEAN THE DUST PACK - If suction is noticeably reduced during cleaning, please check the dust pack as indicated below. Suction is significantly weakened during cleaning. Shaking sound of inlet stuck to the floor (soft mats, blankets, etc.) is heard. SENDER Turn the vacuum power to 'MAX' HANDLE CONTROL...
4-2 CLEANING THE DUST PACK Remove the dust bin and dust Remove the sponge and filter Remove the fixed frame pack as shown. from the dust pack. of the dust pack cover. Wash the sponge and the filter Let the sponge and filter dry in Put the sponge and filter of the dust pack with water.
CHANGE THE BATTERY(OPTIONAL) BATTERY TYPE : AA Size NOTE 1. When the vacuum cleaner does not work, replace the batteries. If the problem persists, please contact our authorized dealer. 2. Use 2 batteries of size AA. 1. Never disassemble or recharge the batteries. 3.