Table of Contents
Advertisement
1 1 / / INSTALLING YOUR APPLIANCE
•
A A d d j j u u s s t t t t h h e e h h o o b b c c o o n n n n e e c c t t i i o o n n s s : : they are
located underneath the knobs (Fig. 04) .
— Proceed one tap at a time.
— Remove the knobs and the gaskets by
pulling them up.
- Switching
from
butane/propane
-
With a small flat-head screwdriver, s s c c r r e e w w i i n n
a a l l l l t t h h e e w w a a y y the brass (yellow) burner power
screws (Fig. 05), i i n n a a c c l l o o c c k k w w i i s s e e d d i i r r e e c c t t i i o o n n . .
-
Replace the gaskets and the knobs, paying
careful attention to their direction and
ensuring that the knobs are pushed in all the
way.
— Switching from butane/propane to natural
-
Unscrew the brass (yellow) burner power
screws (Fig. 05) , using a small flat-head
screwdriver,
b b y y
c c o o u u n n t t e e r r c c l l o o c c k k w w i i s s e e . .
-
Replace the knob,
-
Light the burner in maximum heat mode,
then turn down to reduced heat mode.
-
Remove the knob again, then turn the burner
power screws c c l l o o c c k k w w i i s s e e until it reaches the
lowest possible setting that does not
extinguish the flame.
-
Replace the gasket and knob.
-
Make several attempts to shift from the
maximum flow rate to the minimum: t t h h e e f f l l a a m m e e
s s h h o o u u l l d d n n o o t t g g o o o o u u t t ; ; if it does, unscrew the
burner power screw so as to obtain good
flame
retention
switches.
natural
gas
t t u u r r n n i i n n g g
t t w w o o
during
these
position
to
Fig. 04
t t i i m m e e s s
Fig. 05
47
Knob
Gasket
Tap
Burner power
adjustment screw
Tap axis
Advertisement
Table of Contents
