1) Insert key FPCB into the connector of
9
main PBA.
2) Tighten a screw at the bottom of main PBA.
1)Insert FPCB into
the connector.
2) Tighten a screw.
1) Make sure that key FPCB and connector are assembled
well.
2) Use a cruciform screwdriver.
1) Insert rear cover hook into rear hole.(1)
11
2) Press hooks from the right side of phone to the left side of that.(2)
①
1) Be careful of not scratching on a rear cover and a rear.
This Document can not be used without Samsung's authorization
②
SAMSUNG Proprietary-Contents may change without notice
Exploded View/Disassembly&Assembly Instructions
1) Tighten 4 screws at the top and bottom
10
of rear.
2) Tighten 2 screws in the middle of rear.
1) Make sure that you can distinguish between top-
bottom and middle screws. Top and bottom screws are
identical. But middle screws are different from them.
2) Use a cruciform screwdriver.
③
5-9