Samsung SGH-E740S Service Manual page 22

Exploded View/Disassembly&Assembly Instructions
1) Attach screw caps to screws at the
5
top of slide lower in accord with the
direction(right or left)
2) Attach slide FPCB to the slide
hinge in accord with 2 holes on FPCB.
1)Attach screw
caps.
1) Make sure that you can distinguish between right
and left screw caps.
1) After putting a shield can on front,
7
stick volume key and camera key FPCB to
front.
2) Put mic on front in accord with guide.
1)Stick key
FPCB
2)Put mic on
front
1) Be aware of not damaging on camera key and volume
key FPCBs.
2) Make sure that mic is put into guide hole in good
position.
This Document can not be used without Samsung's authorization
1)Attach FPCB.
1)Stick key
FPCB
SAMSUNG Proprietary-Contents may change without notice
1) Put front into the 2 hooks at the
6
top of slide hinge.
2) Tighten 4 screws.
3) Put main keypad on front.
2)Tighten screws.
1) Use a cruciform screwdriver.
2) After putting front into 2 hooks, tighten screws.
1) Insert slide FPCB into the connector of
8
main PBA.
1) Make sure that slide FPCB and connector are
assembled well.
5-8
1)Insert 2 hooks
into front.