Parts And Functions; Remote Controller - Haier HSU09 VHG(DB)-G&W Service Manual

Parts and Functions

Indoor Unit
1
2
3
4
Inlet
1
Inlet grille
2
3 Outlet
4 Vertical blade
(adjust left and right air flow)
Horizontal flap
5
(adjust up and down air flow.
Don't adjust it manually)
Please be subject to the actual produce purchased the
above picture is just from your reference
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
HSU09VHG(DB)-SM
8
6
7
5
6
Display board
Emergency Switch
7
Air Purifying Filter
8
(inside)
4

Remote controller

1
2
3
4
5
9
10
11
12
13
14
15
16
17
1. Mode display
Operation mode
AUTO COOL DRY HEAT
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
LO MED HI AUTO
5. LOCK display
6. TIMER OFF display
TIMER ON display
7.TEMP display
Healthy function is not available for some units.
Loading of the battery
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
42
System Configration
8. Additional functions display
6
Supplemented
electrical
Operation mode
QUITE SLEEP
heating
Remote controller
7
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
8
13. FAN button
14. TIMER button
18
15. HEALTH button
16. LOCK button
19
Used to lock buttons and LCD display.
20 17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
21
18. POWER ON/OFF button
19. DRY button
22
20. TEMP button
21. SWING button
23
22. HOUR button
23. EXTRA FUNCTION button
24
Function: Air sending--- Healthy
airflow position1--- Healthy airflow
25
position 2 --- Restore the original
flap position --- Right & left air airflow
--- A-B yard---10 and heating symbol
FAN
displayed simultaneously--- Sleeping
--- Electrical heating--- Refresh air
( ---
reserved function)
Fahrenheit/Celsius mode conversion
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this button
to reset the remote
Remove the battery cover;
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
Be sure that the loading
is in line with th
wireless telephone is installed in the
reload several minutes later.
HEALTH POWER
Power ---