Acura 2006 RL Owner's Manual page 69

Vehicle Stability Assist
(VSA) System Indicator
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position.
If it comes on and stays on at any
other time, or it does not come on
when you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. You
will also see a ''CHECK VSA
SYSTEM'' message on the multi-
information display (see page
Take your vehicle to a dealer to have
it checked. Without VSA, your
vehicle still has normal driving ability,
but will not have VSA traction and
stability enhancement. For more
information, see page 339
VSA Activation Indicator
This indicator has three functions.
1. It comes on as a reminder that you
have turned off the vehicle
stability assist (VSA) system.
2. It flashes when VSA is active (see
page 339
3. It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
78 ). You will also see a ''CHECK VSA
SYSTEM'' message on the multi-
information display (see page
This indicator normally comes on for
a few seconds when you turn the
. ignition switch to the ON (II)
position. For more information, see
page 339 .
).
78 ).
Instrument Panel Indicators
Turn Signal and
Hazard Warning
Indicators
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If the indicator does not
blink or blinks rapidly, it usually
means one of the turn signal bulbs is
burned out (see page 374
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signals blink. All
turn signals on the outside of the
vehicle should flash.
). Replace
65