Tuning To Preset Radio Stations; Receiving Rds Radio Station - Philips FW-C220 User Manual

Tuner
Manual programming
1
Press TUNER (BAND).
2
Press TUNER (BAND) again to select the
desired waveband : FM, MW or LW.
3
Press PROGRAM for less than one second.
The PROG flag starts flashing.
The next available preset number will be
displayed for selection.
4
Press à or á to tune to the desired frequency.
¶ If you wish to store the radio station to another
preset number, press 4 or 3 to select the
desired preset number.
5
Press PROGRAM again.
The PROG flag disappears and the radio
station will be stored.
¶ Repeat steps 3 – 5 to store other preset radio
stations.
Notes:
– When 40 radio stations are stored and you
attempt to store another radio station, the display
will show "FULL". If you want to change an
existing preset number, repeat steps 3 – 5.
– You can cancel manual programming by
pressing Ç (on the system only).
– During programming, if no button is pressed
within 20 seconds, the system will exit programme
mode automatically.

Tuning to Preset Radio Stations

¶ Press 4 or 3 to select the desired preset
number.
The preset number, radio frequency, and
waveband appear on the display.
18
pg 01-28/C220/22-Eng
Receiving RDS Radio Station Ç
RDS (Radio Data System) is a broadcasting
service that allows FM stations to send additional
information along with the regular FM radio
signal. This additional information can contain:
¶ STATION NAME: The radio station name is
displayed.
¶ PROGRAM TYPE: The following program
types exist and can be received by your tuner:
News, Affairs, Info, Sport, Educate, Drama,
Culture, Science, Varied, Pop M, Rock M, M.O.R.
(middle of the road music), Light M, Classics,
Other M, No type.
¶ RADIO TEXT (RT): text messages appear in
the display.
When you have tuned to a RDS station, the RDS
logo (Ç) and the radio station name will appear
on the display:
¶ The display normally shows the radio station
name if available.
By repeatedly pressing RDS button you can
change the type of display information:
The display shows in turn:
STATION NAME ™ PROGRAM TYPE ™
RADIO TEXT ™ TUNED FREQUENCY ™
STATION NAME ...
Note:
– When you press the RDS button and the display
shows "NO RDS", it indicates that either the tuned
station is not transmitting RDS signal or it is a non
RDS station.
RDS Clock
Some RDS station may be transmitting a real
clock time at an interval of every minute.
18
3139 115 20671
12/7/00, 1:43 PM