Accessories; Replacement Parts; Installation; Location - Standard Horizon WS150 Owner's Manual

3 Accessories

3.1 Replacement Parts

The following parts may be ordered from the Standard Horizon Parts Department.
To order, call: 562-404-2700 Ext 351
Part ........................................................................................................................................... Part Number
Dust Cover .......................................................................................................................................... DC150
Extension Cable .................................................................................................................................... HS50
Junction Box .............................................................................................................................. M13349001A
Masthead assembly .................................................................................................................. M13349004A
Masthead Cable Assembly (100 feet long) ............................................................................. M13349005A
Panel Gasket .............................................................................................................................. 108013023A
Tricup Assembly ....................................................................................................................... M13349002A
Wind Vane Assembly ................................................................................................................ M13349003A

4 Installation

4.1 Location

The WS150 is designed for above or below deck
installation. Select a position that is:
• At least 12 inches (300mm) from a compass
• At least 20 inches (500mm) from any radio
• Easy to read by the helmsman and crew
• Protected from physical damage
• Accessible to electrical cable connections
WS150 User Manual

4.2 Mounting

The mounting surface must be flat. Use the template
to set the center of the fixing hole.
1 Drill a 1¼" (32mm) diameter mounting hole
through the bulkhead.
2 Remove the nut. Peel the protective paper
off the foam gasket and attach the gasket to
the rear of the instrument.
3 Insert the instrument through the bulkhead.
Hand tighten the nut and then finally tighten
with a spanner. Do not over tighten so that
the water sealing ability of the gasket is
damaged.
7