Memory Scanning; Ch16 Priority Scanning (Pri-Scan) - Standard Horizon Intrepid LE GX1265S Owner's Manual

5.8 MEMORY SCANNING

• During scanning, the dot matrix area of the LCD will show MEM-
SCAN or PRI-SCAN depending on the scan mode selected.
• The channel number shown is the last channel that a transmission
was received on.
1. Adjust the SQL knob just until background noise disappears.
2. Select a desired channel to be scanned using the UP or DOWN
key. Press and hold down the SCAN key until MEM appears in the
LCD to program the channel into the transceiver's memory.
3. Repeat step 2 for all the desired channels to be scanned.
4. To DELETE a channel from the transceiver's memory, press and
hold down the SCAN key again until MEM disappears in the LCD.
5. To start scanning, press the SCAN key. Scanning will proceed from
the lowest to the highest programmed channel number and will stop
on a channel when a transmission is received.
6. To stop scanning, press the SCAN, 16/9, WX, or PTT key.

5.9 CH16 PRIORITY SCANNING (PRI-SCAN)

1. The priority channel is set to channel 16.
2. For priority scanning, hold down the SCAN key until PRI-SCAN
appears in the LCD during memory scanning. Scanning will
proceed between the memorized channels and the priority channel.
The priority channel will be scanned after each programmed
channel.
MEM CH.
page 15
NOTE
CH16 MEM CH.
Owner's Manual
CH16
GX1265S