Preparing Duct Connections - Haier HHX1030 User Manual

English
2. Remove the electrical knockout on the back or top of the range hood
and install a standard electrical cable clamp.
3. Transfer the location of the range hood electrical knockout to either the
bottom of the cabinet or the wall. Drill or cut a hole in the adjoining
surface to make room for the electrical cable clamp.
Preparation for Duct Connection
1. Remove the appropriate ducting knockout by inserting a screwdriver under one
end and prying it up. Then snip or break the attachment points.
2. Install the damper assembly to the range hood with the 2 screws supplied.
3. If discharge is vertical through a rectangular duct, remove the knockout sections
D, B and E only.
4. If the vertical discharge is through a 7" round duct, remove knockout sections
"A" and "B" and "C" only.
Note: Section "D" and "E" remain with the hood.
5. Mount the round collar (E22A -not supplied) over the opening on the hood by
using 3 shorter screws. Allow the bottom edge of the 7" duct to be inserted into
the collar.
7
fig. 2
fig. 3