Faucet Assembly Installation; Sump Valve Installation; Regulator Installation - Frigidaire 241666500 Use & Care Manual

FAUCET ASSEMBLY INSTALLATION

• Attach faucet knob (9) to Faucet & Shank Assembly (6).
• Slip the Faucet & Shank Assembly (6) through the black
plastic collar (7) (flat side toward door), Facade (3), and
hole in door.
• Thread on the large Shank Nut (8) and tighten until snug,
using an adjustable wrench. DO NOT over tighten.
CAUTION CAUTION
CAUTION CAUTION CAUTION
Replacing the faucet knob (9) with a longer knob is not
recommended. This may interfere with the opening of the
freezer door causing beverage spillage and/or damage to
the faucet assembly and door.
SUMP AND DRIP TRAY ASSEMBLY INSTALLATION
• Remove bottom mounting screw.
• Align the two notched mounting tabs on back of sump (1)
with upper mounting screws in door and push up.
• Install bottom mounting screw through slot and tighten.
FIRST STEPS (continued)

SUMP VALVE INSTALLATION

• Place one rubber washer (5) on threaded end of sump
valve (4).
• Slip sump valve with washer through hole in bottom of sump
(1).
• Place remaining rubber washer (5) over threaded end of
sump.
• Thread plastic nut (5) onto threaded end of sump valve and
tighten until snug.
• Make sure knob on valve is located to front for proper
operation.
• Place Drip Tray (2) onto the Sump (1).

REGULATOR INSTALLATION

• Check to ensure plastic washer is inside the hex nut.
N O T E N O T E
N O T E N O T E N O T E
If the plastic washer is missing, please call Electrolux
Consumer Services at 1-800-944-9044 for assistance
• Fasten the CO
the regulator to the right of the tank.
• Tighten the hex nut securely. DO NOT over tighten. Over
tightening may damage the gasket in the nut of the regulator.
9
regulator (10) to the CO canister (16). Place
2 2
.