Gigabyte GA-965P-DQ6 User Manual page 82

(3) Configuring RAID array in RAID BIOS
Enter the RAID BIOS setup utility to configure a RAID array. Skip this step if you do not want to create
RAID.
Step 1:
After the POST memory test begins and before the operating system boot begins, look for a message
which says "Press <Ctrl-G> to enter RAID Setup Utility" (Figure 3). Press CTRL+ G to enter the
GIGABYTE SATA2 RAID BIOS setup utility.
GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOS v1.06.23
Copyright (C) 2005 GIGABYTE Technology.
HDD0 : ST3120026AS
HDD1 : ST3120026AS
ODD0 : GO-D1600D
Press <Ctrl-G> to enter RAID Setup Utility ...
In the main screen of the GIGABYTE SATA2 RAID BIOS utility (Figure 4), use the UP or DOWN ARROW
key to highlight through choices. Highlight the item that you wish to execute and press ENTER.
GIGABYTE Technology Corp. PCIE-to-SATAII/IDE RAID Controller BIOS V1.06.23
[ Main Menu ]
Create RAID Disk Drive
Delete RAID Disk Drive
Revert HDD to Non-RAID
Solve Mirror Conflict
Rebuild Mirror Drive
Save And Exit Setup
Exit Without Saving
[ RAID Disk Drive List ]
[ TAB]-Switch Window
Note: In the main screen, you can select a hard disk in the Hard Disk Drive List block and press
ENTER. This allows you to check detailed information about the selected hard disk.
GA-965P-DQ6 Motherboard
http://www.gigabyte.com
120 GB
120 GB
Figure 3
[ Hard Disk Drive List ]
Mode Name
HDD0: ST3120026AS
HDD1: ST3120026AS
[ ]-Select ITEM [ENTER]-Action
Figure 4
- 82 -
Non-RAID
Non-RAID
Capacity Type/Status
120 GB Non-RAID
120 GB Non-RAID
[ESC]-Exit