Table of Contents
Advertisement
Installing the Software from Windows NT
Perform the following steps to set up the ELP Link III for
Windows NT.
1. Insert the ELP Link III for Windows NT setup disk into a
diskette drive (A: or B: as appropriate).
2. Refer the steps for Windows 3.1 and Windows 95 to
install.
3. The Link III software communicates with the projector
using the computer's serial communication (COM) port.
Specify which COM port to use, then press C to continue.
(Most likely, your computer is using COM 1.)
Installing the Software from Macintosh OS
System (from ver. 7)
Perform the following steps to set up the ELP Link III for the
Macintosh.
1. Insert the ELP Link III for Macintosh Setup disk into the
diskette drive.
2. Copy the ELP III folder from the floppy disk to your local
hard disk with a drag-and-drop action. To be able to use
ELP Link III, restart the system.
• When you install the ELP Link III software, make a new
folder and designate the disk drive to be used.
• Please refer to your Mac Instruction manual.
Installing the Software
63
Advertisement
Table of Contents
