Table of Contents
Advertisement
INSTALLATION
Electrical Connection
• This unit is designed to operate from an adequate supply mentioned at the
rating label sticked to the rear of it.
• In case of 3-core cord: The power cord plug must be connected to an earthed
3-pin power point within reach of the power cord.
• In case of 2 conductor power cord: Connect the grounding wire to a water fau-
cet etc. Make sure that the power cord is unplugged during ground work.
• Do not connect the grounding wire end to a gas tube.
• If the power cord is damaged, it should be replaced by a repair shop appointed
by the manufacturer, because special purpose tools are required.
Connection of Hose
• Attach the water intake hose to the water
inlet located at the left-hand side of the con-
trol panel. Press fit the other end of the hose
to either a hot or cold water tap as required.
(Fig. 1).
Caution: This unit is made of poly propy-
lene, use water below 50°C.
• Attach the drain hose to the drain outlet at
the rear of the base and secure with the
clamp provided.
• The drain hose should be laid flat on the ground. Water flow will be restricted
if any portion of the drain hose is raised 20 cm (8 in) from the ground.
• The opening must not be obstructed by carpeting when the washing machine
is installed on a carpeted floor.
OPERATING INSTRUCTIONS
Preparing the Wash
• Sort the clothes into groups-whites, colorfast, non-colorfast, delicates, lint
free, lint producers, etc., and wash according to the laundry guide.
• Clothes with worn patches or tears should first be mended. Empty out all pock-
ets and close all side fasteners. Treat bad stains prior to washing.
Prior to Washing
• Remove the plastic spin mat from the spin bowl.
• Check that wash timer knob is set to position "0" and that the drain selector
is set to "WASH
RINSE".
•
• Also check that lint filter is correctly positioned.
• Ensure the drain hose is in its correct position (see Installation).
• Inlet power cord plug into the power point and switch on.
To Wash
• Place the wash load and detergent in the wash tub. Refer to "Preparing the
Wash" and "Points to Remember".
• Set the drain selector to "WASH
• Turn the water tap on fill the tub of your washing machine to the level recom-
mended in the Laundry Guide.
WATER INTAKE HOSE
RINSE".
•
2
WATER INLET
Figura 1.
Advertisement
Table of Contents
